equipment and systems communications

Control Units

9 articles

Control Unit AE-100-A

A.L.E. Control Unit

Model AE-100-A

The AE-100-A control unit allows to adapt the HF transceivers or transmitters/receivers equipment to the adaptative protocols for A.L.E. (Automatic Link Establishment) communications techniques.

Control Unit GR-400-A

Dedicated Line Remote Manager

Model GR-400-A

It is a 2/4 wires of dedicated line modem unit to be used together with the GX-400-A (Navtex Remote Control) and that supplies the unit with the possibility of stablishing a data communication channel through an Analogic Dedicated Line of 2/4 wires by means of using a modem model MT5600 series of the company Multitech.

Control Unit TM-100-A

Multicon Remote Controller

Model TM-100-A

Designed to control through modem from one local unit up to 6 Invelco's equipments. It has the possibility to extend in modules of 6 units. As well as the control of equipments through RS-232-C, it can send 10 orders to the remote station or receive 10 alarms from that station.

Control Unit TM-100-B

Multicon Remote Controller

Model TM-100-B

Designed to control through modem from one local unit up to 6 Invelco's equipments. As well as the control of equipments through RS-232-C, it can send 48 orders to the remote station or receive 48 alarms from that station.

Control Unit GX-400-A

Navtex Remote Control

Model GX-400-A

The GX-400-A is the autonomous unit for the automatic/manual management of NAVTEX transmissions in 490 / 518 / 4209.5 KHz. This unit is located in the transmissions centre and will be remotely run by the Navtex Operation program that will conveniently the update the information for the Navtex automatic/manual broadcasts transmissions.

Control Unit TL-400-A

Navtex Remote Controller/Interface

Model TL-400-A

It is a modem unit of 2/4 wires dedicated line to be used with the NAVTEX transmission manager and that gives the NAVTEX system the possibility of establishing a data communications channel through an analogical dedicated line of 2 or 4 wires. In order to do so, it uses the MT5600 Multitech modem.

Control Unit DT-100-A

PTT's/Mutes Detector

Model DT-100-A

The tone discriminator DT-100-A, operates through a telephone line with the tone generator GT-302-A. It allows to decode internally tones sent by the generator, carrying out orders that cannot be sent by an ordinary remote-controller due to is retard in the execution (mute, on and off of equipments, reset of the remote-controllers, orders, etc.).

Control Unit DT-302-A

Reset for Coastal Stations

Model DT-302-A

The DT-302-A tone discriminator is a device that allows to reset the rack that contains the modem, remote control and C70 of the Digital Selective Call of the Global Maritime Distress Safety System.

Control Unit GT-302-A

Reset Generator

Model GT-302-A

The Reset Generator model GT-302-A uses the same communication line that the remote-controller modem to send a reset signal to the coast station. The action is frontal and is temporized to avoid not desired errors in the operation. It can generate up to 10 reset orders.